[zcheng]

ubit0-6:~# fdisk /dev/sda

fdisk: can't open '/dev/sda'

[桃花岛]

zcheng 写道:

ubit0-6:~# fdisk /dev/sda fdisk: can't open '/dev/sda'

我也是这样，退出重新来就成了

[zcheng]

按照office instruction, getting this error:

cd /tmp
wget jeff.doozan.com/debian...ot_mtd0.sh
chmod +x install_uboot_mtd0.sh
./install_uboot_mtd0.sh


-bash-3.2# ./install_uboot_mtd0.sh


!!!!!! DANGER DANGER DANGER DANGER DANGER DANGER !!!!!!

If you lose power to your device while running this script,
it could be left in an unusable state.

This script will replace the bootloader on /dev/mtd0.

This installer will only work on the following devices:
Seagate GoFlex Net
Seagate Dockstar
Pogoplug v1
Pogoplug Pink
Do not run this installer on any other device.

By typing ok, you agree to assume all liabilities and risks
associated with running this installer.

If you agree, type 'ok' and press ENTER to continue: ok
# checking for /usr/sbin/nandwrite...
# checking for /usr/sbin/nanddump...
# checking for /usr/sbin/flash_erase...
# checking for /usr/sbin/fw_printenv...
# checking for /etc/fw_env.config...

# Validating existing uBoot...
Block size 131072, page size 2048, OOB size 64
Dumping data starting at 0x00000000 and ending at 0x00080000...
Connecting to jeff.doozan.com (69.163.187.226:80)
valid-uboot.md5 100% |*******************************| 756 --:--:-- ETA
## Unknown uBoot detected on mtd0: 8915458f228756b5a3db0dbbb3f96b82
##
## The installer could not detect the version of your current uBoot
## This may happen if you have installed a different uBoot on
## /dev/mtd0 or if you have bad blocks on /dev/mtd0
##
## If you have bad blocks on mtd0, you should not try to install uBoot.
##
## If you have installed a diffirent uBoot on mtd0, and understand the
## risks, you can re-run the installer with the --no-uboot-check parameter
##
## Installation cancelled.

[3M]

首先请说明您用的是dockstar还是pogoplug

[zcheng]

3M 写道:

首先请说明您用的是dockstar还是pogoplug

dockstar, 现在已经format好了，到这一步又有问题了：


ubit0-6:/tmp/usb# wget plugapps.com/os/2011.0...011.02-roo
tfs.tar.gz
wget: bad address 'plugapps.com'


为什么呢，为什么呢？不就是个wget吗？wget 前面的script都可以啊

[zcheng]

zcheng 写道:

3M 写道: 首先请说明您用的是dockstar还是pogoplug dockstar, 现在已经format好了，到这一步又有问题了： ubit0-6:/tmp/usb# wget plugapps.com/os/2011.0...011.02-roo tfs.tar.gz wget: bad address 'plugapps.com' 为什么呢，为什么呢？不就是个wget吗？wget 前面的script都可以啊

好了，推出ubit0-6之后就可以下载了

[3M]

你遇到了和其他同样的问题，不知道为什么域名协议失败了。

方法1:

nano /etc/resolv.conf

在文件中增加

nameserver 208.67.222.222
nameserver 8.8.8.8

Ctrl+X -> Y -> 回车 保存退出

方法2 进入ubit环境前先下载好

[桃花岛]

zcheng 写道:

3M 写道: 首先请说明您用的是dockstar还是pogoplug dockstar, 现在已经format好了，到这一步又有问题了： ubit0-6:/tmp/usb# wget plugapps.com/os/2011.0...011.02-roo tfs.tar.gz wget: bad address 'plugapps.com' 为什么呢，为什么呢？不就是个wget吗？wget 前面的script都可以啊

我和你一摸一样，解决方法是先别安装UBIT环境，下载完PlugApps包再安装